output buffer การใช้

• In addition, the Input / output buffer resides in another dynamic memory segment.
• A second improvement is the integration of an optional-use output buffer amplifier to the chip on which the OTA resides.
• This involves all windows being rendered to separate output buffers in memory first, and later combined to form a complete graphical interface.
• When the first L R characters are read to the output, this corresponds to a single run unit appended to the output buffer.
• The original version of PROC utilizes two input buffers ( primary and secondary ), and two output buffers ( primary and secondary ).
• Alternately, Paula may signal the CPU to load a new sample into any of the four audio output buffers by generating an interrupt when a new sample is needed.
• Its text-only nature consumes very little system resources, and it uses an output buffer in a separate daemonizes itself so the audio continues playing in the background.
• After the output buffer had been filled with items the Compute Ortho ( CC ) command was used to calculate the Ortho word and provide the End of Record word.
• On the receive section side and output buffer is driven by the and-gate that picks the channel receive character selected by the channel divider signal at the appropriate time.
• Dr . Alexia Massalin's experimental operating system, Synthesis, would adjust the priority of each task as they ran according to the fullness of their input and output buffers.
• The darlington output buffers on the LM13700 are different from those on the LM13600 in that their bias currents ( and hence their output DC levels ) are independent of IABC pin.
• Newer CMOS output buffers using lightly doped silicide drains are more ESD sensitive; the N-channel driver usually suffers damage in the oxide layer or n + / p well junction.
• If the input lists have K 3 elements total, then a K-funnel fills the output buffer in O ( K 3 / B ( log M / B K 3 / B ) + K ) memory transfers.
• A similar situation can occur at the output of a host ( in the NIC ) when multiple packets have the same or similar release times, and this delay can usually be modelled as a delay in a virtual output buffer.
• To retrieve data from the EPROM, the address represented by the values at the address pins of the EPROM is decoded and used to connect one word ( usually an 8-bit byte ) of storage to the output buffer amplifiers.
• The darlington output buffers provided are specifically designed to complement the wide dynamic range of the OTA . This chip is very useful in audio electronics especially in analog synthesizer circuits like voltage controlled oscillators, voltage controlled filters, and voltage controlled amplifiers.
• Note : " Symmetric parallel termination " means that the termination resistor at the load is connected to half the output buffer's supply voltage . " Double parallel termination " means that parallel termination resistors are fitted at both ends of the transmission line.
• A major flaw of the sound system is that the mixer is not given its own thread, so if the game stalls for too long ( particularly while navigating the menus or connecting to a server ), the small output buffer will begin to loop, a very noticeable artifact.
• A wide variety of front-end processors ( as per common IBM timesharing practice both then and now ), and could therefore function without CPU attention for a considerable amount of time, MUSIC used variable-length time slices, which could, on compute-bound processing, reach a maximum of several seconds per time slice; conversely, if a user filled the output buffer or reached a conversational read, the timeslice would end immediately.
• However, as in ATM, the tolerance may be applied to a lower rate, in that case the segmentation and reassembly ), where the packets are transmitted with a maximum bandwidth determined by the SCR and cells within the packets are transmitted at the PCR; thus allowing the last cell of the packet, and the packet itself, to arrive significantly earlier than it would if the cells were sent at the SCR : transmission duration = ( MBS-1 ) / PCR rather than ( MBS-1 ) / SCR . This bursting at the PCR puts a significantly higher load on shared resources, e . g . switch output buffers, than does transmission at the SCR, and is thus more likely to result in buffer overflows and network congestion.